OASE Aquarius E Fountain Pumps ... Aquarius 4000 E to 7000 E

This Aquarius E  fountain pump has very high capacity displacement that is controlled electronically of a synchronous motor.

OASE Aqarius E Fountain Pump features are:

• 10 mm thick oxide ceramic shaft with permanent magnet and the DFI impeller.

• Stainless steel earthing plates and a electronic overload circuit that offers optimal safety.

•  The OASE Aquarius E is simple to clean and has a long life service.

• Enables infinite flow rate adjustment with a controller on the pump's suction duct.

• After removing the filter, the Aquarius E fountain pump can be connected to an external pre-filter.

• Included with this Aquarius E fountain pumps is an adjustable 1" swivel ball joint with a hose diameter connection of between 3/4" to 1 1/2"

Calculate running cost by multiplying watts/1000 and then multiply by the cost per kWhr of electricity in your area see also the free pond calculators to help you)

Note that all OASE Aquarius E pumps have a rated voltage of 220-240 V/50 Hz, 1 pressure side threaded connection, a 3"/4"  to 1" connection for hoses,34 mm suction side connection. The filter surface for each Aquarius pump is 1150 cm²  the pumps have a weight of 3 kg for a cable length of 10 m.

OASE Aquarius E-S Fountain Pumps are Seawater resistant

Seawater resistant are tested also suitable for dependable implementation, and function in high-saline water. The secret about this OASE Aquarius E-S is the Double Floaded Impeller (DFI) system which makes the pump to have high performance, axial-load free operation.

• When using the OASE Aquarius E-S, continuous operation characteristics are not effected.

• Aquarius E-S pumps have special pedestal with rubber pads that offer silent operation.

• Hose connection on the pressure and suction ducts enables the OASE Aquarius pump to operate out of water.

• This Aquarius E-S comes equipped with a thermal cut off switch and a 3m cable.